B-LOC B400 25mm

Product #B401025

Rating
Not yet rated
Write | View
The B-LOC B400 Series 25mm Keyless Bushing provides a high capacity, zero-backlash shaft to hub connection for shafts measuring 25mm in diameter by means of a mechanical interference fit and transmits up to a maximum of 472 Nm of torque.

Your Price: $49.94

Contact Customer Support

+1-800-243-3374
or
+1-717-665-2421
or
+44 (0) 870 7577007

Best Suited For: Applications that require a recessed installation of the bushing with no axial movement of the mounted component relative to the shaft during tightening.

B-LOC B400 Series 25mm Keyless Bushings provide a zero-backlash frictional connection that will never wear or pound out and can accommodate high-torque, thrust, bending, and/or radial loads. Their self-releasing double taper design permits simple adjustment and removal and there is no axial movement during installation. Since the B-LOC B400 Series Keyless Bushings do not have a flange, the external diameter along the unit’s entire length is the same, therefore allowing the unit to be completely inserted into the component bore for flushed or recessed mounting.

• Self-releasing double taper design permits simple adjustment and removal
• No axial movement during installation
• Recessed installation without the need for a counterbore

Note: This product is not self-centering but Fenner Drives offers pilot bushings that provide pre-centering when required. The pilot bushings are supplied in sets of three (3) bushings and three (3) longer screws (replace plated locking screws).

Features of Fenner Drives Keyless Bushings:

• Ability to transmit higher torques
• True zero-backlash
• Less equipment downtime
• Ability to mount over existing keyways
• Complete axial and radial adjustability
• Simple installation, adjustment and removal

All Fenner Drives keyless locking devices operate using the simple wedge principle. An axial force is applied- by either a hex nut (Trantorque) or a series of annular screws (B-LOC)- to engage circular steel rings with mating tapers. The resulting wedge action creates a radial force on the tapered rings, one of which contracts to squeeze the shaft while the other expands and presses into the component bore.

  • Series: B400
  • Torque Transmission: 472
  • Axial Movement: No
  • Bore Tolerance: 50.08
  • Component Bore Diameter: 50mm
  • Hub Pressure: 118
  • Installation Torque: 15 Nm
  • Internal/ External: Internal
  • Material: Steel
  • Metric/Inch: Metric
  • Releasing/ Locking: Releasing
  • Screw Size: M6 x 18
  • Self-Centering: No
  • Shaft Diameter: 25mm
  • Shaft Tolerance: 24.92
  • Taper: Double
  • Thrust: 37756

Average Customer Rating

Not yet rated

To write a review you must Log In

Need Help?

Please only use this form for questions or comments specifically related to products or information on this particular page. For any other questions or comments, please use our general contact us form.

  •  

  •  

  •  
  •  
Back To Top